Forums
New posts
Articles
Product Reviews
Policies
FAQ
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Menu
Log in
Register
Install the app
Install
Forums
General Discussions
Switcher Hangout (Windows to Mac)
Fault CR2
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MarkAllread" data-source="post: 1870419" data-attributes="member: 399743"><p>That would have been my guess too. Or maybe power supply. Maybe too much load on the PS.</p><p>Have you done the usual reset of SMC (on Mac Pro just disconnect power cable, leave for a minute or so, (I always press and hold power button for few seconds too) and then power up again).</p><p>If it was my Mac Pro, before going deeper, I'd probably run EtreCheck, then pull all the RAM except 1 stick just to be sure.</p></blockquote><p></p>
[QUOTE="MarkAllread, post: 1870419, member: 399743"] That would have been my guess too. Or maybe power supply. Maybe too much load on the PS. Have you done the usual reset of SMC (on Mac Pro just disconnect power cable, leave for a minute or so, (I always press and hold power button for few seconds too) and then power up again). If it was my Mac Pro, before going deeper, I'd probably run EtreCheck, then pull all the RAM except 1 stick just to be sure. [/QUOTE]
Verification
Name this item. 🍎
Post reply
Forums
General Discussions
Switcher Hangout (Windows to Mac)
Fault CR2
Top
