CWA107..I tried to fond the Mac folder with the setup for mac folder and could not find it. How do you do the manual config via the web interface?
Start with all devices powered OFF. This includes your cable/DSL modem and computer.
1. Run an ethernet cable from your Cable/DSL modem to the Internet (gray port) at the rear of the DIR-655.
2. Run another ethernet cable between the ethernet port on your Mac and one of the four ports on the bank of ports at the rear of the router.
3. Connect the power to your cable/DSL modem. Wait 30 seconds.
4. Connect the power to the DIR-655. Wait 30 seconds.
5. Boot your Mac.
6. Open Safari on the Mac, you might get an error message that the page can not be displayed. That's OK for now.
7. In the address bar, type:
192.168.0.1
8. You'll be prompted for a username/password. Enter admin for the username, leave the password field blank.
9. Now you should be able to configure your router. Follow the instructions in your manual.