A
ashley24
Guest
I recently purchased memory for my 1.8 GHz PowerMac G5 from memoryupgrade.com. I attempted to install 2 1GB memory sticks this morning in addition to the 2 156 MB memory sticks that came standard with the machine. After installation, the computer will not reboot. Instead it blinks twice indicating that there is no RAM installed.
I tried removing the new memory and rebooting with the old and the same result. I tried rebooting with only the new memory as well as switching the slots for the two with the same result. Any suggestions!?!?! I tried contacting memoryupgrade.com with no such luck. Some technician is supossed to contact me later today but I don't have much hope.
I wore an anti-static wrist strap and have had no problems installing memory in the past. Did I ruin both pairs of memory or is there a way to at least make the old memory work? This is the main prepress computer in the printing department and I need it up and running ASAP. Any suggestions would be greatly appreciated!!!!
I tried removing the new memory and rebooting with the old and the same result. I tried rebooting with only the new memory as well as switching the slots for the two with the same result. Any suggestions!?!?! I tried contacting memoryupgrade.com with no such luck. Some technician is supossed to contact me later today but I don't have much hope.
I wore an anti-static wrist strap and have had no problems installing memory in the past. Did I ruin both pairs of memory or is there a way to at least make the old memory work? This is the main prepress computer in the printing department and I need it up and running ASAP. Any suggestions would be greatly appreciated!!!!