Hello board people! I have a new mystery for yous guys. I'm transplanting an iPhone 11 into it's new home in a replacement back housing. Everything had gone well until plugging the charging port ribbon cable into the logic board. I have the other cables plugged into the very bottom of the board and the bracket in place over those, but the connector both seems longer than necessary, and isn't held in place in the socket very securely. This combination means it pops out of the connector before I can even think of putting the batter/charging cable bracket over it to secure in place. Anyone else experienced this? Do I have to replace the connector itself? If so, it looks like some not very easy soldering.