D
daktafari
Guest
I’ve recently had ethernet wire installed for a network. I have a Power Mac G3 233 and an iMac connected via a Linksys router. I followed the directions as outlined in a Macworld article Dec 2000 that Linksys has a link to on its website (including the TCP/IP information). I upgraded the ethernet extention on my Powermac to 2.0.4 (from 2.0.1). I am on a cable modem from Comcast. My problem is the severely marked degradation in speed (slower than a dial up connection) noted when the system is active as compared to when the cable modem is directly connected to my powermac . On the Linksys router, the “full/col” and “100” LEDs do not light up on the powermac port but do on the iMac port when either or both computers are on line. I have replaced the router but the same problem occurs. I was expecting to lose a “little” speed but this is rediculous. Any suggestions?