I have a 500mhz iMac G3. It meets the system requirements of Jaguar. When I try to install Jaguar. It begins the process, but after 4 min or so, it freezes. I tried every combination of my 64mb, 128mb, and 256mb sticks of ram. Jaguar installed fine when I used it on my iBook.
My iMac can still boot into Mac OS 9.2.2, and the firmware is up-to-date.
I'm using a set of two retail Jaguar CDs with big, furry X's on them.
The iMac does read other CDs.
I have tried different RAM combos, I bought the 128mb module from RAMdirect. After that didn't work, I bought a 256mb module which was perviously used in somebody's iMac. When I use just the 128mb module, instead of freezing, the screen goes black into an MS-DOS-like command line. It gives me the following message:
The installer has quit due to an unexpected error. (exit code 0)
My problem didn't get a solution at Apple's Discussion Forums, so I decided to see if anyone here knew anything.
My iMac can still boot into Mac OS 9.2.2, and the firmware is up-to-date.
I'm using a set of two retail Jaguar CDs with big, furry X's on them.
The iMac does read other CDs.
I have tried different RAM combos, I bought the 128mb module from RAMdirect. After that didn't work, I bought a 256mb module which was perviously used in somebody's iMac. When I use just the 128mb module, instead of freezing, the screen goes black into an MS-DOS-like command line. It gives me the following message:
The installer has quit due to an unexpected error. (exit code 0)
My problem didn't get a solution at Apple's Discussion Forums, so I decided to see if anyone here knew anything.