I have searched this forum and attempted several times and ways to use time capsule to restore to a new hard drive on my mac book running leopard. I installed the new hard drive, used the leopard install disk to format and partition the drive. After that I tried once to use airport and once to use ethernet (faster) to restore. Each time I received the "you need to restart your computer" message. When I restarted the computer it came back to the same message. Besides many hours of work, I am extremely frustrated and hope that this is not an issue with time capsule since I hold a lot of data on it, and fortunately not a crash, but a hard drive upgrade from the 160gb to a 320gb unit. I have 2 identical computers I am upgrading and I am getting the same results with both computers, so I dont think it is a corrupt hard drive or hardware issue unless it is in the time capsule.
I know this should not be this hard to figure out and complete. Can anyone tell me where I am going wrong here, and what the potential issues could be.
Thanks,
David
I know this should not be this hard to figure out and complete. Can anyone tell me where I am going wrong here, and what the potential issues could be.
Thanks,
David