- Joined
- Jun 4, 2011
- Messages
- 2
- Reaction score
- 0
- Points
- 1
The hard drive in my older G5 (dual 2.0) has a bad block on the factory drive and will not allow my OS (running 10.5.4) to start up. I bought a new 500gb Western Digital SATA drive to put into the machine and it will not see the drive when I go to install the OS. I re-installed the OS into the old drive and it is working properly at this point but for how long I do not know. Is there anything special I need to do to get my machine to see this drive. Any assistance would be greatly appreciated. Thanks in advance.