- Joined
- May 19, 2010
- Messages
- 1
- Reaction score
- 0
- Points
- 1
Good Evening All,
Being a mechanical / structural engineer, I am planning to have create my own design business by early 2012.
I am working with Mac for my photo works at home and am planning to use Mac for my future engineering works.
I have been working a lot with the different versions of Solidworks, Catia & Autodesk Inventor over the last few years but they are not available in Mac versions.
Does any of you know a software equivalent to them, providing both conception of components (2D & 3D), assemblies, mechanical design & simulation?
That's a bit of a tricky question but I'm sure one of you cn be of good advice!
Thanks for that, Cheers,
Olivier
Being a mechanical / structural engineer, I am planning to have create my own design business by early 2012.
I am working with Mac for my photo works at home and am planning to use Mac for my future engineering works.
I have been working a lot with the different versions of Solidworks, Catia & Autodesk Inventor over the last few years but they are not available in Mac versions.
Does any of you know a software equivalent to them, providing both conception of components (2D & 3D), assemblies, mechanical design & simulation?
That's a bit of a tricky question but I'm sure one of you cn be of good advice!
Thanks for that, Cheers,
Olivier
