Results 1 to 3 of 3
  1. #1
    Maxtor external HDD detection issues on Macbook

    Member Since
    Apr 05, 2010
    Posts
    1
    Angry Maxtor external HDD detection issues on Macbook
    I use a maxtor 500GB external HDD to store my music and videos. My macbook runs Mac OSX 10.4.11. A few months ago, my macbook started having trouble detecting this drive when plugged in. Sometimes, the drive will work fine. Other times, it will power up, make some noise for a long time, then power down without being detected.

    Recently, it completely stopped being recognized. The drive does show up in disk utility, but I have tons of data on this disk that I really need to recover, and I don't want to reformat it without backing it up.

    I also noticed that on those few occasions that it used to be detected, if the usb cable was touched even slightly, the disk would be disconnected.

    PLZ HALP!!

  2. #2
    Maxtor external HDD detection issues on Macbook
    chscag's Avatar
    Member Since
    Jan 23, 2008
    Location
    Fort Worth, Texas
    Posts
    45,269
    Specs:
    27" iMac i5, 3.2 GHz, iPad 3, iPhone 5c, iPhone 6+, 3 iPods, Yosemite
    Have you tried a new USB cable? You might have a flakey cable. If it's not the cable (assuming you tried a new one) then the drive itself may be getting ready to fail. If you need to get your data off the drive and can't through normal means, you might try "Data Rescue 3".

    Regards.

  3. #3
    Maxtor external HDD detection issues on Macbook

    Member Since
    Mar 28, 2010
    Posts
    23
    Specs:
    MacBook Pro 15.4" 2.4GHz i5 OS X 10.6.3
    This may be a hardware failure on the part of the Maxtor HDD.

    Usually it means the controller inside the enclosure goes out. Fortunately, it also means that you can remove the drive from the enclosure, install it in a new one and be back up and running.

    Check the cable as chscag suggests and also try different USB ports to eliminate that as a potential cause.

    If neither of these remedy your issue, then you'll need to take the next step and put the HDD in a new enclosure and go from there. If that doesn't work, then the drive is bad.

    Not to be the bearer of bad new but Maxtor drives have a history of high failure rates. If you can get it up and running, I would suggest you get your data off it and onto another drive ASAP.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Issues with Maxtor OT4 external hard drive
    By Echo Hans in forum Other Hardware and Peripherals
    Replies: 1
    Last Post: 12-24-2012, 01:47 PM
  2. Help External HDD Issues
    By joshhumber in forum OS X - Operating System
    Replies: 3
    Last Post: 04-05-2010, 04:08 PM
  3. HDD Partition and Detection Problem
    By KiranC in forum Other Hardware and Peripherals
    Replies: 8
    Last Post: 05-19-2009, 09:41 AM
  4. Maxtor HDD is Read Only!!! Only
    By alixreza in forum Other Hardware and Peripherals
    Replies: 3
    Last Post: 01-31-2008, 07:28 AM
  5. HDD & Maxtor One Touch III Opinion
    By i-VTEC in forum Other Hardware and Peripherals
    Replies: 2
    Last Post: 07-02-2006, 11:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •