04-09-2009, 11:59 PM #1While running 10.5 on one HD, can I boot to another HD running system 9?
I'm trying to see if I can setup my computer in a certain manner so that I can run OS 10.5.6 on one hard drive and have the capability to reboot my computer from another hard drive that is running system 9.2.2.
Here's my basic setup: I have a duel processor G4 MDD (2 x 1Ghz) with an 80gb ATA drive set as the master w/slave, with system 10.5.6 running on it. I have a second ATA drive set as the slave that I want to install system 9.2.2 on and be able to boot back and forth between hard drives. Is this possible?
I've been trying to install system 9 on the second drive but have been unsuccessful so far with messages that say I can't run this system on my machine. I first tried to install before the second drive was formatted at all (fresh out of the box from OWC). Then I formatted it while running 10.5.6 as a single partition with OS 9 drivers and still could not get it to show up after booting from my system 9 disks.
Any help, advice or information would be appreciated. Thanks in advance.
04-10-2009, 12:26 AM #2
- Member Since
- Oct 10, 2004
- 27" 3.4 Ghz i7 iMac-13" C2D Macbook-OSX 10.10.2 -64Gb iPad 2-64 Gb iPhone 6+-ATV 2-14Tb of Storage
Set the secondary drive to "Cable Select" vice "Slave" and see what happens.
There is no reason you should not be able to boot from an OS9 instal disc and instal OS9 on the secondary drive. I assume this is what you are doing.
04-10-2009, 12:48 AM #3
- Member Since
- Nov 28, 2007
- Nambucca Heads Australia
- iMac i5 2.7GHz, 16GB memory, OS 10.11.1.
04-10-2009, 12:59 AM #4
Hello and thank you both for your replies. My computer is the Apple Power Macintosh G4 1.0 DP (MDD) Specs (M8689LL/A).
I'm going to double check my jumper settings and make sure I have them in the correct order. About using the cable select setting, I'm not familiar with how this works but I did a little research and found a place where it said that cable select would be used on both drives if I go this route. Is this correct?
Also just to confirm I have my master/slave settings right, am I correct that the master drive is at the end of the cable and the slave in the middle?
Thanks again for your help.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By KJGMacSkype in forum OS X - Operating SystemReplies: 1Last Post: 12-28-2012, 08:26 AM
By pugsley in forum OS X - Operating SystemReplies: 2Last Post: 02-21-2012, 05:28 PM
By rogerson123 in forum Apple DesktopsReplies: 6Last Post: 09-08-2010, 07:12 PM
By pphil09 in forum Apple NotebooksReplies: 2Last Post: 12-23-2008, 01:12 AM
By CL33Zero in forum Apple NotebooksReplies: 2Last Post: 08-21-2007, 03:44 AM