- Joined
- Jan 27, 2012
- Messages
- 6
- Reaction score
- 0
- Points
- 1
Trying to get the following USB adapter work with a MacBook Pro
Newegg.com - Rosewill RNX-EasyN1 Wireless-N 4.0 Dongle (1T1R) IEEE 802.11b/g/n USB 2.0 Up to 150Mbps Data Rates WPA/WPA2 (AES, 64,128-WEP with shared-key authentication) WPS PIN, PBC (Hardware WPS Button) QoS-WMM
And well I install the drivers.. Then plug in the adapter.. The rosewill wireless utility pops up on the site survey screen and says no device!! in the bottom left hand corner after some spinning wheel goes for a bit..
. It doesnt show up in Networks or anything.. In the utility screen I cant really do anything.. Clicking Add doesnt do crap in the profile page and such I get the spinning wheel for awhile then nothing.. This Mac is on 10.6.8
Im at a total loss as to what to do.. Not really a big Mac expert im quite befuddled .
Any suggestions would be most helpfull thanks
Newegg.com - Rosewill RNX-EasyN1 Wireless-N 4.0 Dongle (1T1R) IEEE 802.11b/g/n USB 2.0 Up to 150Mbps Data Rates WPA/WPA2 (AES, 64,128-WEP with shared-key authentication) WPS PIN, PBC (Hardware WPS Button) QoS-WMM
And well I install the drivers.. Then plug in the adapter.. The rosewill wireless utility pops up on the site survey screen and says no device!! in the bottom left hand corner after some spinning wheel goes for a bit..
. It doesnt show up in Networks or anything.. In the utility screen I cant really do anything.. Clicking Add doesnt do crap in the profile page and such I get the spinning wheel for awhile then nothing.. This Mac is on 10.6.8
Im at a total loss as to what to do.. Not really a big Mac expert im quite befuddled .
Any suggestions would be most helpfull thanks