Mac Forums

Mac Forums (http://www.mac-forums.com/forums/)
-   OS X - Development and Darwin (http://www.mac-forums.com/forums/os-x-development-darwin/)
-   -   Trying to install and compile JTR? (http://www.mac-forums.com/forums/os-x-development-darwin/187462-trying-install-compile-jtr.html)

msh1916 01-20-2010 12:56 AM

Trying to install and compile JTR?
 
I'm new to this - obviously.
I just put 10.6 on my MacBook
I downloaded JTR to Desktop.
I know enough to cd in terminal to src as they say to do.
Then it starts getting confusing for me.
It says to use Make (i'm assuming its a command.
If I type that in or what's next: 'make clean system' or 'make clean generic' terminal says command not found.
I'm baffled and obviously don't know that much about terminal.
I must be stupid b/c I need step by step help
Any help anyone could give would be greatly apprecaited.

Matt
msh1916@gmail.com

cradom 01-20-2010 10:30 AM

In order to compile/install source you need to install Developer Tools.
Also, if the install doesn't start with a ./configure, it's possible the source is a *nix only and will not compile on a Mac.
What exactly is JTR? And where did you get it?

msh1916 01-20-2010 03:11 PM

JRT is John the Ripper
 
JTR is fairly common software, from my understanding.

There are instructions, however b/c of my lack of knowledge I need almost letter by letter instructions.

Sorry bout that.

Matt

cradom 01-20-2010 10:44 PM

Well, I found this: How to crack Mac OS X passwords
However, like I said, you need to install Apple Developer Tools to compile.
(should be on your install disk)

EDIT: may not be on your install disk, however you can get it free here: http://developer.apple.com/mac/
free membership required, free download


All times are GMT -4. The time now is 08:29 PM.

Powered by vBulletin
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.