01-30-2011, 06:57 AM #1
'shared library error' message in Pro Tools
- Member Since
- Jan 30, 2011
I am trying to open a Pro Tools session but keep getting this error message:
shared library error. "3<Pro Tools PPC dbg><DAE><DSI><DsiWriteHostRegister>"
I have Pro Tools HD 6.9.2 on a dual 2.7 GHz Power PC GS, 6 GB DDR SDRAM, running on OS X 4.8 . With 2 internal hard drives.
What happened was everything was running fine for years, until a few days ago I tried to load Pro Tools 8 (Digidesign install disk from the studio I work at). The disk wouldn't read, so I upgraded the OS to OS X 4.11 & this is when it seemed everything went nuts (computer wouldn't boot, had to boot from install disk & switch boot drives, in which the computer turned on with no problem.
After doing some reading on the Avid forums, I reset the PRam & NVRAM, did a zero erase on the boot drive after backing it up & repaired disk permissions from the 'disk utility' located in the install disk menu. After this, when I tried to launch Pro Tools I received the 'unable to locate Digidesign Hardware' error message that wouldn't go away even tho' everything was on, connected & working fine previously.
I then uninstalled & re-installed Pro Tools from the original install disk & now I'm receiving the 'shared library error' message.
I know this sounds quite complicated, but if anyone here has experience with this type of message (of which I can find NOTHING about it on the Avid support site or ANY PTs forum so far) I would greatly appreciate your assistance.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Survive in forum Apple NotebooksReplies: 0Last Post: 07-15-2010, 05:13 PM
By johnjacob1029 in forum Music, Audio, and PodcastingReplies: 1Last Post: 04-18-2009, 01:26 PM
By shaunfitz in forum OS X - Operating SystemReplies: 0Last Post: 09-20-2008, 04:38 PM
By curlydesign in forum OS X - Operating SystemReplies: 2Last Post: 03-19-2005, 07:57 PM
By curlydesign in forum OS X - Apps and GamesReplies: 0Last Post: 03-18-2005, 05:54 PM