02-03-2006, 03:19 PM #1joyous jorgeGuestibook g3 does not find airport card that is installed
hello my ibook g3 says the appropiate hardware is not found on the computer when i start airport admin utility. I just installed the original airport card and it doesn't recognize the hardware. what do i do? my os is 10.2.8 and my airport is 3.1.1. I tried to install airport 3.1.1 again but the system says it still does not find the airport card and says for me to install it and shut it down. ...help...
02-04-2006, 08:14 AM #2
- Member Since
- May 22, 2005
- Closer than you think.
- Performa 6116 2GBSCSI 8MB OS 7.5.3
Does it show up in system profiler?
02-19-2006, 11:11 AM #3mink03Guest
I am having the same problem. It was recognized before then I took it out at one point to check out my ram, now its not detected at all. i didnt bend any pins or anything.. and it doesnt appear in system profiler. is there some sort of hardware detection i can use.. how do i know what airport i have? (i think its the original) and I have tiger..should i reinstall tiger? i dont know what to do
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Nerdrii in forum OS X - Operating SystemReplies: 4Last Post: 10-07-2012, 04:52 PM
By riegeronimo in forum Internet, Networking, and WirelessReplies: 1Last Post: 06-25-2009, 02:57 PM
By mamapedio in forum Switcher HangoutReplies: 5Last Post: 11-07-2007, 01:19 AM
By caswey in forum Internet, Networking, and WirelessReplies: 1Last Post: 03-22-2005, 09:35 PM