View Single Post
BillS

 
Member Since: Jun 05, 2009
Posts: 1
BillS is on a distinguished road

BillS is offline
Did you check the settings on the printer's web interface? There are settings for toner density and draft/quality modes. Either one may produce the lighter prints.

Did you try deleting & re-adding the printer in case there is a corrupt preference?

We have been using this printer for two years with few problems with OSX 10.4 & 10.5. Our first printer jammed all the time, but after HP replaced it we have not had the problem. Once in a while the printer will stop responding and we need to power cycle it in order to print again. We also had the printer reset to Factory Defaults because we accidently pressed both buttons at the same time. Other than that we've been happy with the printer.
QUOTE Thanks