View Single Post
Vanderdecken

 
Vanderdecken's Avatar
 
Member Since: Jan 10, 2009
Posts: 6
Vanderdecken is on a distinguished road

Vanderdecken is offline
Hello and thank you both for your replies. My computer is the Apple Power Macintosh G4 1.0 DP (MDD) Specs (M8689LL/A).

I'm going to double check my jumper settings and make sure I have them in the correct order. About using the cable select setting, I'm not familiar with how this works but I did a little research and found a place where it said that cable select would be used on both drives if I go this route. Is this correct?

Also just to confirm I have my master/slave settings right, am I correct that the master drive is at the end of the cable and the slave in the middle?

Thanks again for your help.

-Vanderdecken
QUOTE Thanks