Results 1 to 8 of 8
  1. #1
    DIY: Fix Mac Pro Bluetooth Range Issues
    iggibar's Avatar
    Member Since
    Apr 20, 2009
    Location
    C-Town
    Posts
    4,071
    Specs:
    Mac Pro 4.1 15" MBP. 13" MBP. 17" PB. Power Mac G5. Galaxy Note 4 160gb*
    DIY: Fix Mac Pro Bluetooth Range Issues
    What does this tutorial fix?
    The notorious bluetooth range issues on Mac Pros caused by bluetooth to aluminum grounding issues never fixed by Apple.

    What models can be fixed with this tutorial?
    All Mac Pro models can use this method. However, Mac Pro 1.1 -3.1 have an easier fix that involves the swapping of wifi and bluetooth cables to fix the issue. That method isn't as easy on the 4.1+ models since they have revised logic boards with different Airport and bluetooth locations

    What do you need for this DIY method?
    The minimum required for this fix to work minimum:
    - ~20" U.fl IPX to RP-SMA Male cable
    -RP-SMA antenna. 2dBi depending on range needed. A good 2dBI antenna will work better than a cheap antenna that is rated at 10 or more dBi! Don't buy junk! Range distribution also is an issue when going above 2dBi. Most home routers use 2dBi, so it should be more than enough for a Mac Pro to work if it is located with the same room as the bluetooth device.

    My Mac Pro 4.1 was only 4 feet 5 inches from the trackpad, but the bluetooth signal was too weak to pass through the aluminum. I wanted to test something, so I went the dual antenna route, but the 2dBi antenna worked perfect. What you see in the pic below is a 20" U.fl IPX cable, spare PCI card slot cover, 2dBi D-link antenna, 9dBi antenna with base, and RP-SMA male to two RP-SMA female adapter.

    All but the PCI cover and small antenna can be purchased on eBay for ~$20 shipped.

    Here we go!

    Make sure you are wearing a grounding harness, especially when working around carpet or around other fabrics.

    Step 1.
    Get your Mac Pro. Unplug all wires from the back. With the Mac Pro now off, hold the power button for 15 seconds. Start removing the processor tray, graphics card, and any other PCI cards for convenience.


    Step 2.
    Drill a whole in the PCI cover to accommodate the female end of the antenna.


    Step 3.
    Secure the antenna onto the PCI cover, and route the antenna as neatly as possible inside. Make sure it has enough room to easily be connected to the bluetooth board. At the same time, don't let it come close to the rear fan. Place the PCI cover into the PCI slot.


    Step 4.
    The bluetooth cable we are putting out of commission is labeled "BT." Disconnect it from the board by pulling the head straight up.


    Step 5. With tape or a rubber tube, cover the old bluetooth cables end to prevent any possible shortages. Connect the new antenna head by pushing it straight down. I used the wire clip to secure the taped end.



    Step 6.
    Put your Mac Pro back together.

    That's all the work required inside.

    With the antenna connection at the back, you can decide if you want to connect straight to an antenna, or use an extension to place the antenna elsewhere. I tried both routes by using a splitter. The connection only got better at distances that were completely useless to me, so I returned to the single 2dBi antenna.

    You can go with a small antenna:


    Big antenna:


    Or both with a splitter:



    As I mentioned earlier, the quality of antenna will give you different results. A good 2dBi antenna will work more than enough for a room, while a cheap one might not show any improvements. The 9dBi antenna works just as well in the same room, but has noticeable strength when operating the magic trackpad outside the house(!).

    This problem is so easy to fix, yet there are people replacing their Mac Pro because of this issue.
    “If you are distressed by anything external, the pain is not due to the thing itself but to your own estimate of it; and this you have the power to revoke at any moment.” Marcus Aurelius

  2. #2
    DIY: Fix Mac Pro Bluetooth Range Issues
    pigoo3's Avatar
    Member Since
    May 20, 2008
    Location
    U.S.
    Posts
    31,462
    Specs:
    2011 13" MBP 2.3ghz, 8gig ram, OS 10.7.5
    WOW...one heck of detailed writeup iggibar...with some really great photos. Real nice DIY bluetooth fix.

    When I had my 2009 Mac Pro 4,1...I don't think that I ever used the bluetooth for anything...so I guess I didn't have the unfortunate experience of finding out how poor the bluetooth performance was.

    - Nick
    - Too many "beachballs", read this: Beachballs
    - Computer seems slower than it used to? Read this for some slow computer tips: Speedup
    - Almost full hard drive? Some solutions. Out of Space
    - Apple Battery Info. Battery

  3. #3
    DIY: Fix Mac Pro Bluetooth Range Issues
    harryb2448's Avatar
    Member Since
    Nov 28, 2007
    Location
    Nambucca Heads Australia
    Posts
    20,009
    Specs:
    iMac i5 2.7GHz, 16GB memory, OS 10.10.5
    Very interesting.

    When using Mac Pro 2.1 never had any Bluetooth troubles. Airport sand Bluetooth always worked faultlessly.
    Hang on to those original install discs like grim death! Using OS X.7 or later make a bootable USB thumb drive before running Installer!

  4. #4
    DIY: Fix Mac Pro Bluetooth Range Issues
    iggibar's Avatar
    Member Since
    Apr 20, 2009
    Location
    C-Town
    Posts
    4,071
    Specs:
    Mac Pro 4.1 15" MBP. 13" MBP. 17" PB. Power Mac G5. Galaxy Note 4 160gb*
    There's a few threads on Apple's site, with one being 10+ pages.
    Looks like the distance people notice problems with is after 3 feet. I have a bunch of things that I believe are interfering with it as well, especially after installing the new triple-monitor stand. All is good now though. I have yet to find something that shows what causes this issue, but my guess is that there is a problem with the chip at the end of the original bluetooth's antenna(hidden next to the PCI slot covers), and the antenna is left to pick up data from the short wire leading to that chip. Having this issue seems to be a hit or miss though, and does not show true span of the problem since not everyone uses bluetooth.
    “If you are distressed by anything external, the pain is not due to the thing itself but to your own estimate of it; and this you have the power to revoke at any moment.” Marcus Aurelius

  5. #5
    DIY: Fix Mac Pro Bluetooth Range Issues
    iggibar's Avatar
    Member Since
    Apr 20, 2009
    Location
    C-Town
    Posts
    4,071
    Specs:
    Mac Pro 4.1 15" MBP. 13" MBP. 17" PB. Power Mac G5. Galaxy Note 4 160gb*
    Just wanted to update folks a bit. Ever since I did this fix on my Mac Pro, I haven't had a single issue, not even as the batteries were totally depleting.
    “If you are distressed by anything external, the pain is not due to the thing itself but to your own estimate of it; and this you have the power to revoke at any moment.” Marcus Aurelius

  6. #6
    DIY: Fix Mac Pro Bluetooth Range Issues
    pigoo3's Avatar
    Member Since
    May 20, 2008
    Location
    U.S.
    Posts
    31,462
    Specs:
    2011 13" MBP 2.3ghz, 8gig ram, OS 10.7.5
    Quote Originally Posted by iggibar View Post
    Just wanted to update folks a bit. Ever since I did this fix on my Mac Pro, I haven't had a single issue, not even as the batteries were totally depleting.
    I was just rereading this thread...and looking at all the photos of the parts used. Normally bluetooth range (I think) is around 20-30 feet. With the rig you got going...I'm thinking your bluetooth range should be something like Cleveland to Pittsburgh!

    - Nick
    - Too many "beachballs", read this: Beachballs
    - Computer seems slower than it used to? Read this for some slow computer tips: Speedup
    - Almost full hard drive? Some solutions. Out of Space
    - Apple Battery Info. Battery

  7. #7
    DIY: Fix Mac Pro Bluetooth Range Issues
    iggibar's Avatar
    Member Since
    Apr 20, 2009
    Location
    C-Town
    Posts
    4,071
    Specs:
    Mac Pro 4.1 15" MBP. 13" MBP. 17" PB. Power Mac G5. Galaxy Note 4 160gb*
    Hahaaa! I'm happy it 's such an easy fix. I've mentioned this to a few other, and they have been problem free since. It amazes me that Apple continues to replace logic boards, and whole systems to try and fix it, when it has nothing to do with those. Get's me mad thinking too much about it.
    “If you are distressed by anything external, the pain is not due to the thing itself but to your own estimate of it; and this you have the power to revoke at any moment.” Marcus Aurelius

  8. #8
    DIY: Fix Mac Pro Bluetooth Range Issues

    Member Since
    Dec 16, 2013
    Posts
    1
    I can confirm that this fix works - finally I can move on with my life. These are the items on ebay that I used:

    RP SMA 2 4GHz 7 dBi Wireless WiFi WLAN 5 x Range Booster Antenna Extender Base | eBay

    20inch U FL IPX to RP SMA Female RF Pigtail Jumper Cable for PCI WiFi Card 50cm | eBay

    The range booster is pretty small but clearly sufficient for my needs, i.e. a magic mouse.

    Thanks iggibar!

    /Alex

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to get better wireless range on Mac Pro
    By LondonMike in forum Internet, Networking, and Wireless
    Replies: 20
    Last Post: 01-20-2010, 01:20 PM
  2. Logic Board Failure - Afraid To DIY Fix It!
    By EvilAsa93 in forum Apple Notebooks
    Replies: 4
    Last Post: 08-18-2009, 01:08 PM
  3. Wireless range on my Mac Book Pro
    By boomops in forum Internet, Networking, and Wireless
    Replies: 2
    Last Post: 07-03-2009, 06:23 PM
  4. DIY bluetooth
    By seanarmenta in forum Apple Desktops
    Replies: 0
    Last Post: 03-09-2007, 03:42 AM
  5. powerbook wireless range fix?
    By Wally in forum Apple Notebooks
    Replies: 3
    Last Post: 06-21-2005, 02:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •